To avoid spending hours with manual layout and painfully slow methods to fabricate rubber contact Miller Mechanical’s Waterjet shop. Shown below are a few custom gasket strips for lock maintenance on the Hudson River. They just needed a quick trim on one end and a series of holes so they could be mounted to an installation plate. The installation plates were pre-fabricated, so hole location was critical for fit-up. The fit was perfect when completed, and based on documented times was approximately 10X faster than traditional methods of layout and manual punching. Contact us today to see how we can turn difficult to fabricate materials from soft profit into hard earnings. Patrick@millermech.com
You must be logged in to post a comment.