Below are a series of photos that are the beginnings of a fully constructed Diamondback® which will eventually be shipped to a facility in Tennessee. Photo 1, Mike is shown forming the 304L stainless steel which is approximately ½ inch in thickness. Photo 2, are the sheets of steel that have been formed and are ready for fabrication. Photo 3, the vessel is in the final stages of fabrication. This vessel will eventually have another layer added to the base. It will then be cleaned, painted, a final Q.C. and shipped. Eventually it is to be used in the pulp and paper facility as a means to funnel wood chips.
You must be logged in to post a comment.